Its signification depends on the driver, but as you get closer to the AP or the station, the signal gets higher.
Signal level reported by the Wi-Fi adapter. In this unassociated state, it is searching for an AP to connect with. In the Client section, a BSSID of “(not associated)” means that the client is not associated with any AP.
In the example above the client rate of “36-24” means: In the example above, “WPA handshake: 00:14:6C:7E:40:80” indicates that a WPA/WPA2 handshake was successfully captured for the BSSID. The first line shows the current channel, elapsed running time, current date and optionally if a WPA/WPA2 handshake was detected. ivs format or merge them.Īirodump-ng will display a list of detected access points, and also a list of connected clients (“stations”). C : Uses these frequencies in MHz to hop band : Band on which airodump-ng should hop You can make it capture on other/specific channel(s) by using: essid-regex : Filter APs by ESSID using a regularīy default, airodump-ng hop on 2.4GHz channels. background : Override background detection. : Output file(s) write interval in seconds ignore-negative-one : Removes the message that says Pcap, ivs, csv, gps, kismet, netxml, logcsv uptime : Display AP Uptime from Beacon Timestamp manufacturer : Display manufacturer from IEEE OUI list berlin : Time before removing the AP/client update : Display update delay in seconds beacons : Record all beacons in dump file It is possible, but not recommended, to run Kismet and airodump-ng at the same time. Before running airodump-ng, you may start the airmon-ng script to list the detected wireless interfaces.
0 kommentar(er)
